Dome Classic System (Archive)

Assembly-friendly classics thanks to the use of fewer components. Available elevated on one/two sides.
  • Is suitable for nearly all types of flat roofs. It is very easy to install using fewer K2 System components
  • A system for statically difficult roofs and special applications
  • Can also be mounted on ­trapezoidal sheet metal roofs
  • Quick and easy handling

Technical data

D-Dome S-Dome
Scope of application Flat roofs ≤ 5° with single ply membrane or bituminous roof covering, also on concrete, gravelled or green roofs; also trapezoidal sheet metal roofs with continuous mounting rails Flat roofs ≤ 5° with single ply membrane or bituminous roof covering, also on concrete, gravelled or green roofs; also trapezoidal sheet metal roofs with continuous mounting rails
Fastening type / roof fixture Ballasted; no roof penetration for inclination ≤ 3° Ballasted; no roof penetration for inclination ≤ 3°
Requirements
  • Permissible module dimensions (L × W × H): 1386-2300 × 950-1100 × 30-50mm
  • Minimum system size: 2 supports (4 modules)
  • Module approved for corner clamping (see approved modules…)
  • Permissible module dimensions (L × W × H): 1386-2067 × 950-1100 × 30-50mm
  • Minimum system size: 2 modules
  • Module approved for corner clamping (see approved modules…)
Technical specifications
  • Thermal separation after max. 12m (trapezoidal sheet metal 8.8m)
  • Minimum clearance to roof edge 600 mm
  • Thermal separation after max. 12m (trapezoidal sheet metal 8.8m)
  • Minimum clearance to roof edge 600 mm
Inclination angle 10° 10°
Material
  • Mounting rails, D-Dome, Dome SD, Module Clamps, Rail Connectors: Aluminium EN AW-6063 T66
  • Building protection mat with or without aluminium lining (PUR-bound rubber granules)
  • Small parts: Stainless steel (1.4301) A2-70
  • Mounting rails, S-Dome, Dome SD, Windbreaker, module clamps, rail connectors: Aluminium EN AW-6063 T66
  • Building protection mat with or without aluminium lining (PUR-bound rubber granules)
  • Small parts: Stainless steel (1.4301) A2-70

Downloads

Product data sheet

Brochure - Flat roof systems

Assembly instructions - D-Dome Classic

Assembly instructions - S-Dome Classic

Assembly instructions - Dome trapezoidal sheet metal

General Assembly and Maintenance Instructions

Checklist Flat roof

Tender specification - D-Dome

Tender specification - S-Dome

Certificate Structural Analyses - D-Dome

Certificate Structural Analyses - S-Dome

Expert's report wind loads - D-Dome

Expert's report wind loads - S-Dome

Module approval flat roof systems: Dome Classic

Recommendations lightning protection and equipotential bonding

Protocol Static Friction (Coefficient of Friction)

TerraGrif - Potential equalisation